Inflatable / October 10, 2018 / Zurie Chandonnet
The planning dependence upon an indoor pocket of gas leads to a necessity for a really durable surface material and/or simple repair of tears and holes on the material since a puncture or tear will result within the escape of the gas inside (a leak) and also the deflation of the inflatable which depends upon the gass pressure to hold its form. Detectable leaks can be caused by holes (from punctures or tears) on the material the separating of seams the separating of valve components or an improperly close or improperly closing valve. Even if an inflatable possesses no macroscopic leaks the gas inside will usually diffuse out of the inflatable albeit at a much slower rate until equilibrium is reached while using pressure outside the inflatable.
Next you should tightly secure the blower(s) to the inflatable tube(s) and close any other inflation tubes. Now you should check to see if the location has an electricity outlet with a GFI box. Refer back to the blower manufacturers owners manual to check the correct electricity requirements extension cord type generator information etc. Now once the electricity requirements have been satisfied you can inflatable the product. After the product is fully inflated you will need to fasten all of the tie downs using the correct required stakes to anchor the inflatable into position.
If you have purchased a used product you can still inquire about getting an owners manual from the bounce house manufacturer. Usually the owners manual will display a step-by-step instruction of how to setup and teardown an inflatable product. This will also cover where the tie downs are where the enter and exits ramps are located where and when to use the product what age group it is designed for and space requirements. The details covered in an owners manual will differ from company to company since one will be more thorough or precise with clearer images than the other.