Inflatable / October 10, 2018 / Zurie Chandonnet
Next you should tightly secure the blower(s) to the inflatable tube(s) and close any other inflation tubes. Now you should check to see if the location has an electricity outlet with a GFI box. Refer back to the blower manufacturers owners manual to check the correct electricity requirements extension cord type generator information etc. Now once the electricity requirements have been satisfied you can inflatable the product. After the product is fully inflated you will need to fasten all of the tie downs using the correct required stakes to anchor the inflatable into position.
If youve owned one of the older cheaper style inflatable boats you know you also have to invest in repair patches or a roll of duct tape. New high quality inflatable kayaks are changing peoples impressions of inflatable boats. New inflatable crafts are made from puncture and abrasion resistant rubber often reinforced with polyester fabric. This is much stronger than the PVC material used for most cheap inflatable boats. Under normal circumstances it is quite unlikely that you would puncture these new rubber materials. Even if you did most inflatable kayaks have at least three separate air chambers.
Once all anchors are fastened and the inflatable is fully inflated the delivery person can now check to make sure that wires are not causing a tripping hazard there are no sharp objects protruding near or on the inflatable there are no overhead power lines and so forth. Making sure every precautions are taken to ensure safety. Most often than not an injury will occur when a delivery person gets too careless about setting up the inflatable and doesnt follow all the safety steps. Inflatable products should never be used during certain weather conditions. Winds over 20-25 miles per hour can cause the inflatable to move or if the speed is high enough to make it airborne.