Inflatable / October 5, 2018 / Laetitia Beauchesne.
If youve owned one of the older cheaper style inflatable boats you know you also have to invest in repair patches or a roll of duct tape. New high quality inflatable kayaks are changing peoples impressions of inflatable boats. New inflatable crafts are made from puncture and abrasion resistant rubber often reinforced with polyester fabric. This is much stronger than the PVC material used for most cheap inflatable boats. Under normal circumstances it is quite unlikely that you would puncture these new rubber materials. Even if you did most inflatable kayaks have at least three separate air chambers.
The planning dependence upon an indoor pocket of gas leads to a necessity for a really durable surface material and/or simple repair of tears and holes on the material since a puncture or tear will result within the escape of the gas inside (a leak) and also the deflation of the inflatable which depends upon the gass pressure to hold its form. Detectable leaks can be caused by holes (from punctures or tears) on the material the separating of seams the separating of valve components or an improperly close or improperly closing valve. Even if an inflatable possesses no macroscopic leaks the gas inside will usually diffuse out of the inflatable albeit at a much slower rate until equilibrium is reached while using pressure outside the inflatable.
The fabrics that produce inflatable boats are very light in weight. For Sea Eagle inflatable dinghy SE 9 it is only weight 38lbs for the boat and 74lbs for boat floorboard and motor mount(For your info SE 9 could be loaded with 1200lbs or 5 adults).Using the comparison of as light as air in inflatable boats is no over-exaggerated. The light weight of inflatable boats makes inflatable boats launch easier. Only 2 adults are needed to carry out the inflatable boat from water after using. The light weight of inflatable boats just makes people love inflatable boats more.
But as with most things in life things change. In the last five years most U.S. "manufacturers" have thrown in the towel and are no longer making their own Inflatables. Theyre now importing China made Inflatables and passing them off as "Made in the U.S.A." In addition a new breed of internet phonies are posing as "manufacturers" and selling "China made Inflatables" or acting as a distributor for some other inflatable company importing from China. The fact of the matter is there are only a few manufacturers left that still build their entire product line of Inflatables right here in the good old U.S.A. Its more expensive but far superior in durability. And yes in spite of what you have been told there is a big difference in Safety Quality Craftsmanship.