Inflatable / January 27, 2019 / Esperanza Langlais
Delivery in any closed van or pickup truck (with products securely fastened down) would do. Before you can start actually setting up an inflatable product you should be very confident that you KNOW how to setup and operate your moon bounce. You might want to check how many tie downs are required weight of each tie down electricity requirements weight capacity and so forth. Now once you have arrived at your setup location you should first examine the area to make sure there will be enough flat evened space with no overhead objects. Once this has been satisfied you can begin rolling out your product as designated in the owners manual.
Paying a little more for your Inflatables can save you a lot of money in the long run not to mention a whole lot of aggravation and lost customers! Buying the cheapest Inflatables can many times turn out to be a very expensive mistake. You should ask yourself how much in lost rental revenue you will incur if that bargain Inflatable falls apart in a few months right in the middle of your busy season. A lot more than you might think. And good luck trying to get it fixed in less than a month or two. (Especially if it has to be shipped back to China for repairs.) During that time you would have lost 10-15 rentals multiplied by your average rental rate which could cost you as much as Two Thousand Dollars or more each time your China Inflatable is out for repair.
The DVD Ant Farm has directions for creating your personal inflatables using plastic bags and an iron. The low technological barrier to building inflatables is additional lowered by DIY instruction sets like the Inflatocookbook. The inflatable party rentals industry is relatively premature when compared to other industries for party equipment and supplies rental. For instance there is no authoritative bounce house safety organization to control the inflatable rental industry. The top safety regulatory organizations are the states which designate the safety rules for that particular area and if there are no such rules then they follow those set by the ASTM.