Inflatable / February 5, 2019 / Esperanza Langlais
If youve owned one of the older cheaper style inflatable boats you know you also have to invest in repair patches or a roll of duct tape. New high quality inflatable kayaks are changing peoples impressions of inflatable boats. New inflatable crafts are made from puncture and abrasion resistant rubber often reinforced with polyester fabric. This is much stronger than the PVC material used for most cheap inflatable boats. Under normal circumstances it is quite unlikely that you would puncture these new rubber materials. Even if you did most inflatable kayaks have at least three separate air chambers.
Delivery in any closed van or pickup truck (with products securely fastened down) would do. Before you can start actually setting up an inflatable product you should be very confident that you KNOW how to setup and operate your moon bounce. You might want to check how many tie downs are required weight of each tie down electricity requirements weight capacity and so forth. Now once you have arrived at your setup location you should first examine the area to make sure there will be enough flat evened space with no overhead objects. Once this has been satisfied you can begin rolling out your product as designated in the owners manual.
Next you should tightly secure the blower(s) to the inflatable tube(s) and close any other inflation tubes. Now you should check to see if the location has an electricity outlet with a GFI box. Refer back to the blower manufacturers owners manual to check the correct electricity requirements extension cord type generator information etc. Now once the electricity requirements have been satisfied you can inflatable the product. After the product is fully inflated you will need to fasten all of the tie downs using the correct required stakes to anchor the inflatable into position.