Inflatable / January 26, 2019 / Laetitia Beauchesne
But as with most things in life things change. In the last five years most U.S. "manufacturers" have thrown in the towel and are no longer making their own Inflatables. Theyre now importing China made Inflatables and passing them off as "Made in the U.S.A." In addition a new breed of internet phonies are posing as "manufacturers" and selling "China made Inflatables" or acting as a distributor for some other inflatable company importing from China. The fact of the matter is there are only a few manufacturers left that still build their entire product line of Inflatables right here in the good old U.S.A. Its more expensive but far superior in durability. And yes in spite of what you have been told there is a big difference in Safety Quality Craftsmanship.
The planning dependence upon an indoor pocket of gas leads to a necessity for a really durable surface material and/or simple repair of tears and holes on the material since a puncture or tear will result within the escape of the gas inside (a leak) and also the deflation of the inflatable which depends upon the gass pressure to hold its form. Detectable leaks can be caused by holes (from punctures or tears) on the material the separating of seams the separating of valve components or an improperly close or improperly closing valve. Even if an inflatable possesses no macroscopic leaks the gas inside will usually diffuse out of the inflatable albeit at a much slower rate until equilibrium is reached while using pressure outside the inflatable.
Next you should tightly secure the blower(s) to the inflatable tube(s) and close any other inflation tubes. Now you should check to see if the location has an electricity outlet with a GFI box. Refer back to the blower manufacturers owners manual to check the correct electricity requirements extension cord type generator information etc. Now once the electricity requirements have been satisfied you can inflatable the product. After the product is fully inflated you will need to fasten all of the tie downs using the correct required stakes to anchor the inflatable into position.